Support | V23 System Requirements

The following are the recommended system requirements for BobCAD-CAM V23.

• 2.0 GHz Processor
• 2 GB Ram
• 2 GB Available Hard Disk (Used for Paging File)
• Windows XP / Windows Vista / or Windows 7
• 512 MB Graphics Adapter* that supports OpenGL 1.1

For Windows Vista stations we suggest an ATI graphics card or an NVIDIA 7000 series or below. Minimum System Requirements:

• 2 GHz Processor 1 GB Ram
• 2 GB Available Hard Disk (Used for Paging File)
• Windows XP / Windows Vista / or Windows 7
• 128 MB Graphics Adapter* that supports OpenGL 1.1

NOTE: This configuration will allow the system to run, but there will be some delay in the execution of commands

The BobCAD-CAM V23 system is a solids and surface modeling system. If you are using a computer that has less RAM than the minimum requirements listed above, you may experience delays in executing functions that relate to rendering models, generating toolpath and G-Code programs. Understand that these delays are not caused by the BobCAD-CAM software. By upgrading your computer to the recommended requirements above, you will be able to execute those functions more efficiently.

Pre-tested Computer Configurations

Please Note: "64-Bit Operating Systems: BobCAD-CAM V23 is a 32-Bit application. Although the system must run in 32-Bit mode it can be installed and will operate properly on a 64-Bit operating system. The installation for the application places the executable and all of the necessary support files in the proper folder to run in 32-Bit compatibility mode. "